ASTM E1854-13
確保電子部件的中子引起的位移損傷試驗一致性的標準實施規程

Standard Practice for Ensuring Test Consistency in Neutron-Induced Displacement Damage of Electronic Parts

被代替

標準號

ASTM E1854-13

發布

2013年

發布單位

美國材料與試驗協會

替代標準

ASTM E1854-19

當前最新

ASTM E1854-19

 

 

引用標準

ASTM E1018 ASTM E1249 ASTM E1250 ASTM E1297 ASTM E170 ASTM E181 ASTM E1855 ASTM E2005 ASTM E2450 ASTM E261 ASTM E262 ASTM E263 ASTM E264 ASTM E265 ASTM E393 ASTM E481 ASTM E482 ASTM E496 ASTM E523 ASTM E526 ASTM E666 ASTM E668 ASTM E704 ASTM E705 ASTM E720 ASTM E721 ASTM E722 ASTM E798 ASTM E844 ASTM E944 ASTM F1190 ASTM F980

適用范圍

4.1 This practice was written primarily to guide test participants in establishing, identifying, maintaining, and using suitable environments for conducting high quality neutron tests. Its development was motivated, in large measure, because inadequate controls in the neutron-effects-test process have in some past instances resulted in exposures that have differed by factors of three or more from irradiation specifications. A radiation test environment generally differs from the environment in which the electronics must operate (the operational environment); therefore, a high quality test requires not only the use of a suitable radiation environment, but also control and compensation for contributions to damage that differ from those in the operational environment. In general, the responsibility for identifying suitable test environments to accomplish test objectives lies with the sponsor/user/tester and test specialist part of the team, with the assistance of an independent validator, if available. The responsibility for the establishment and maintenance of suitable environments lies with the facility operator/dosimetrist and test specialist, again with the possible assistance of an independent validator. Additional guidance on the selection of an irradiation facility is provided in Practice F1190.

4.2 This practice identifies the tasks that must be accomplished to ensure a successful high quality test. It is the overall responsibility of the sponsor or user to ensure that all of the required tasks are complete and conditions are met. Other participants provide appropriate documentation to enable the sponsor or user to make that determination.

4.3 The principal determinants of a properly conducted test are: (1) the radiation test environment shall be well characterized, controlled, and correlated with the specified irradiation levels; (2) damage produced in the electronic materials and devices is caused by the desired, specified component of the environment and can be reproduced at any other suitable facility; and (3) the damage corresponding to the specification level derived from radiation environments in which the electronics must operate can be predicted from the damage produced by the test environment. In order to ensure that these requirements are met, system developers, procurers, users, facility operators, and test personnel must collectively meet all of the essential requirements and effectively communicate to each other the tasks that must be accomplished and the conditions that must be met. Criteria for determining and maintaining the suitability of neutron radiation environments for 1-MeV equivalent displacement damage testing of electronics parts are presented in Section 5. Mandatory requirements for test consistency in neutron displacement damage testing of electronic parts are presented in Section 5. Additional background material on neutron testing and important considerations for gamma dose and dose rate effects are presented in (non-mandatory) Appendix X1 and Appendix X2, but compliance is not required.

推薦

誰引用了ASTM E1854-13 更多引用