Prehybridization and probe labeling

?

Prehybridization Set hybridization oven to 65°C. Thaw 32 P isotope in hood. Place membrane in hybridization tube. Add 50 mL of prehybridization buffer to each tube. Prehybridization buffer [for 4 probes]

ddH2 0	125 mL
20X SSPE	60 mL
100X Denhardt's solution	10 mL
20% SDS	5 mL
Salmon sperm DNA [10 mg/mL; boil for 5 minutes and set on ice 5 minutes before adding]	1 mL
TOTAL	200 mL

Prehybridize membranes for at least 6 hours to overnight.

Probe labeling Heat water to boiling in a beaker on a hot plate. Labeling components are Labeling components

DNA	1.0 μL [20?50 ng]
ddH2 0	4.0 μL [total volume of H2 0 and probe = 5 μL]
Oligo primers	1.0 μL
dNTPs [5 mM]	1.5μL
Klenow polymerase	1.0 μL
10X Klenow buffer	1.5μL
dCTP 32 P	5.0 μL
TOTAL	15.0 μL

Conbine ddH2 0, oligo primer, and DNA in a 1.5-ml microfuge tube, boil for 4 minutes, and place on ice. Add dNTPs, 10X buffer, Klenow enzyme, and 32 P. Mix, spin briefly, and allow reaction to go overnight at room temperature or place at 37°C for 2 hours.

Column preparation Add glass wool to the base of a 1-mL syringe and place in a 15-mL centrifuge tube. Using a transfer pipet, fill the syringe with a solution of Sephadex G-50 in TE. Avoid getting air bubbles in the column. Centrifuge tubes for ~30 seconds, refill tubes with fresh Sephadex G-50 solution, and centrifuge at 1,500 RPM for 4 minutes. Add 200 μL of TE to each column and centrifuge for 4 minutes at 1,500 RPM. Probe purification Add 185 μL of TE to each probe. Cut the cap off the tube and withdraw all of the probe solution from the tube with a pipet. Place an empty tube under the syringe and add the probe to the top of the column. Spin the column for 4 minutes at 1,500 RPM. Discard the column; remove tube with pruified probe and recap. Add a cap-lock to the tube, boil for 4 minutes, and place on ice.

?