ISO 5163:2014
石油產品.發動機和航空燃料抗爆特性的測定.馬達法

Petroleum products - Determination of knock characteristics of motor and aviation fuels - Motor method

標準號

ISO 5163:2014

發布

2014年

發布單位

國際標準化組織

當前最新

ISO 5163:2014

 

 

引用標準

ASTM D2100-95 ASTM D2699-13 ASTM D2700-12 ASTM D357-67 ASTM D614-67 ISO 3170:2004 ISO 3171:1988 ISO 3696:1987 ISO 4787:2010

適用范圍

This International Standard establishes the rating of liquid spark-ignition engine fuel in terms of an arbitrary scale of octane numbers using a standard single-cylinder, four-stroke cycle, variablecompression ratio, carburetted, CFR engine operated at constant speed. Motor octane number (MON) provides a measure of the knock characteristics of motor fuels in automotive engines under severe conditions of operation. The motor octane number provides a measure of the knock characteristics of aviation fuels in aviation piston engines, by using an equation to correlate to aviation-method octane number or performance number (lean-mixture aviation rating). This International Standard is applicable for the entire scale range from 0 MON to 120 MON, but the working range is 40 MON to 120 MON. Typical motor fuel testing is in the range of 80 MON to 90 MON. Typical aviation fuel testing is in the range of 98 MON to 102 MON. This International Standard is applicable for oxygenate-containing fuels containing up to 4,0 % (m/m) oxygen and for gasoline containing up to 25 % (V/V) ethanol. NOTE 1 Although 25 % (V/V) of ethanol corresponds to approximately 9 % (m/m) oxygen, full applicability of this test method for that oxygen range has only been checked for gasoline type of fuels. NOTE 2 ethanol. Work is under way to check the possibility to use the method for gasoline containing up to 85 % (V/V) NOTE 3 This International Standard specifies operating conditions in SI units but engine measurements may be specified in inch-pound units because these were the units used in the manufacture of the equipment, and thus some references in this International Standard include these units in parenthesis. NOTE 4 For the purposes of this standard, the terms “% (m/m)” and “% (V/V)” are used to represent the mass fraction, μ, and the volume fraction, φ, of a material respectively.

推薦

誰引用了ISO 5163:2014 更多引用