ASTM E521-23
使用帶電粒子輻照研究中子輻射損傷影響的標準實施規程

Standard Practice for Investigating the Effects of Neutron Radiation Damage Using Charged-Particle Irradiation

標準號

ASTM E521-23

發布

2023年

發布單位

美國材料與試驗協會

當前最新

ASTM E521-23

 

 

引用標準

ASTM C859 ASTM E170 ASTM E910 ASTM E942

適用范圍

1.1 This practice provides guidance on performing chargedparticle irradiations of metals and alloys, although many of the methods may also be applied to ceramic materials. It is generally confined to studies of microstructural and microchemical changes induced by ions of low-penetrating power that come to rest in the specimen. Density changes can be measured directly and changes in other properties can be inferred. This information can be used to estimate similar changes that would result from neutron irradiation. More generally, this information is of value in deducing the fundamental mechanisms of radiation damage for a wide range of materials and irradiation conditions. 1.2 Where it appears, the word “simulation” should be understood to imply an approximation of the relevant neutron irradiation environment for the purpose of elucidating damage mechanisms. The degree of conformity can range from poor to nearly exact. The intent is to produce a correspondence between one or more aspects of the neutron and chargedparticle irradiations such that fundamental relationships are established between irradiation or material parameters and the material response. 1.3 The practice appears as follows: Section Apparatus 4 Specimen Preparation 5 – 10 Irradiation Techniques (including Helium Injection) 11 – 12 Damage Calculations 13 Postirradiation Examination 14 – 16 Reporting of Results 17 Correlation and Interpretation 18 – 22 1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM E521-23相似標準

推薦

誰引用了ASTM E521-23 更多引用