• <li id="ccaac"></li>
  • <table id="ccaac"><rt id="ccaac"></rt></table>
  • <td id="ccaac"></td>
  • <td id="ccaac"></td>
  • 實驗方法> DNA實驗技術> DNA基礎知識>DNaseI Foot printing

    DNaseI Foot printing

    關鍵詞: DNaseI Foot printing來源: 互聯網

    ?

    ?

    An end labeled DNA probe is incubated with a purified DNA-binding factor or with a protein extract. The unprotected DNA is then digested with DNase I such that on average, every DNA molecule is cut once. Digestion products are then resolved by electrophoresis. Comparison of the DNase I digestion pattern in the presence or absence of protein will allow the identification of a footprint (protected region).

    1. Make the DNA binding reaction by combining the following components in a microcentrifuge tube:

    25 &mu;l of protein extract in HEMG

    10 &mu;l of 10% Polyvinyl Alcohol

    1 &mu;l of 1 M HEPES, pH 7.6

    2 fmol of end-labeled DNA probe (about 1200 cpm)

    1 to 5 &mu;g competitor DNA

    and bring the final reaction volume to 50 &mu;l with ddH2 O.

    2. Mix the components gently and incubate on ice for 10 min (for incubations with purified proteins, incubation temperatures may be increased).

    3. Add 50 &mu;l of Ca/Mg Solution to the binding reaction at room temperature.

    4. Add 1 to 10 &mu;l of DNase I solution (see Hint #1).

    5. Mix quickly and incubate at room temperature for 1 min.

    6. Stop the reaction by adding 100 &mu;l of stop solution and mix by vortexing immediately.

    7. Add 200 &mu;l of phenol/chloroform and mix by inverting several times. Centrifuge at full speed in a microcentrifuge for 10 min to separate the phases. Recover the aqueous phase and transfer it to a fresh microcentrifuge tube.

    8. Add 1 ml of 100% ethanol and mix by inverting several times.

    9. Centrifuge at full speed in a microcentrifuge for 10 min to pellet the DNA and remove the ethanol.

    10. Resuspend the pellet in 70% ethanol and pellet the DNA again. Remove the ethanol and allow the DNA pellet to air dry.

    11. Resuspend the DNA in 6 &mu;l formamide dye and load the sample onto a 6% to 8% sequencing gel (see Protocol on Sequencing Gel Protocol).

    ?

    Competitor DNA ? Sonicated Calf Thymus DNA in ddH2 O
    ?
    Formamide Dye ? 0.005% (w/v) Xylene Cyanol FF 20 mM EDTA make up in deionized Formamide 0.005% (w/v) Bromophenol Blue
    ?
    70% (v/v) Ethanol
    ?
    1:1 Phenol:Chloroform
    ?
    Stop Solution ? 1% (w/v) SDS 0.2 M NaCl Store at room temperature 20 mM EDTA, pH 8.0 0.25 mg/ml carrier RNA
    ?
    Ca/Mg Solution ? 5 mM CaCl2 10 mM MgCl2
    ?
    DNase I ? 2.5 mg/ml in ddH2 O Freeze as 2-5 &mu;l aliquots and store at -70℃
    ?
    HEMG ? 0.1 mM EDTA, pH 8.0 0.1 M KCl 25 mM HEPES, pH 7.6 with KOH 12.5 mM MgCl2 10% (v/v) Glycerol 1 mM DTT (add just before use)
    ?
    1 M HEPES ? pH 7.6 with KOH
    ?
    10% (v/v) Polyvinyl Alcohol

    Competitor DNA Sonicated Calf Thymus DNA in ddH2 O

    Formamide Dye 0.005% (w/v) Xylene Cyanol FF

    20 mM EDTA

    make up in deionized Formamide

    0.005% (w/v) Bromophenol Blue

    70% (v/v) Ethanol

    1:1 Phenol:Chloroform

    Stop Solution 1% (w/v) SDS

    0.2 M NaCl

    Store at room temperature

    20 mM EDTA, pH 8.0

    0.25 mg/ml carrier RNA

    Ca/Mg Solution 5 mM CaCl2

    10 mM MgCl2

    DNase I 2.5 mg/ml in ddH2 O

    Freeze as 2-5 &mu;l aliquots and store at -70℃

    HEMG 0.1 mM EDTA, pH 8.0

    0.1 M KCl

    25 mM HEPES, pH 7.6 with KOH

    12.5 mM MgCl2

    10% (v/v) Glycerol

    1 mM DTT (add just before use)

    1 M HEPES pH 7.6 with KOH

    10% (v/v) Polyvinyl Alcohol

    推薦方法

    Copyright ?2007 ANTPedia, All Rights Reserved

    京ICP備07018254號 京公網安備1101085018 電信與信息服務業務經營許可證:京ICP證110310號

  • <li id="ccaac"></li>
  • <table id="ccaac"><rt id="ccaac"></rt></table>
  • <td id="ccaac"></td>
  • <td id="ccaac"></td>
  • 床戏视频