非常抱歉,我們暫時無法提供預覽,您可以試試: 免費下載 ASTM D4402/D4402M-2015 前三頁,或者稍后再訪問。
點擊下載后,生成下載文件時間比較長,請耐心等待......
5.1x00a0;This test method is used to measure the apparent viscosity of asphalts at handling, mixing, or application temperatures.
5.2x00a0;Some asphalts may exhibit non-Newtonian behavior under the conditions of this test method, or at temperatures within the range of this test method. Since non-Newtonian viscosity values are not absolute properties, but reflect the behavior of the fluid within the particular measurement system, it should be recognized that measurements made by this test method may not always predict field performance under the conditions of use.
5.3x00a0;Comparisons between non-Newtonian viscosity values should be made only for measurements made with similar conditions of temperature, shear rate, and shear history.
1.1x00a0;This test method outlines a procedure for measuring the apparent viscosity of asphalt from 38 to 260x00b0;C [100 to 500x00b0;F] using a rotational viscometer and a temperature-controlled thermal chamber for maintaining the test temperature.
1.2x00a0;The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3x00a0;This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See 10.6 for specific precautionary information.
Copyright ?2007-2022 ANTPEDIA, All Rights Reserved
京ICP備07018254號 京公網安備1101085018 電信與信息服務業務經營許可證:京ICP證110310號