ASTM D2162-2013
標準粘度計和粘性油標準的基本校正的標準實施規程

Standard Practice for Basic Calibration of Master Viscometers and Viscosity Oil Standards

非常抱歉，我們暫時無法提供預覽，您可以試試： 免費下載 ASTM D2162-2013 前三頁，或者稍后再訪問。

注意： 點擊下載后，生成下載文件時間比較長，請耐心等待......

標準號

ASTM D2162-2013

發布日期

2013年

實施日期

廢止日期

無

國際標準分類號

17.060 (Measurement of volume, mass, density, visc

發布單位

US-ASTM

適用范圍

5.1x00a0;Because there are surface tension or kinematic viscosity differences, or both, between the primary standard (7.4) and kinematic viscosity standards (7.5), special procedures using master viscometers are required to x201c;step-upx201d; from the kinematic viscosity of the primary standard to the kinematic viscosities of oil standards.

5.2x00a0;Using master viscometers calibrated according to this practice, an operator can calibrate kinematic viscometers in accordance with Specifications D446.

5.3x00a0;Using viscosity oil standards established in this practice, an operator can calibrate kinematic viscometers in accordance with Specifications D446.

1.1x00a0;This practice covers the calibration of master viscometers and viscosity oil standards, both of which may be used to calibrate routine viscometers as described in Test Method D445 and Specifications D446 over the temperature range from 15 to 100x00b0;C.

1.2x00a0;The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.2.1x00a0;The SI-based units for calibration constants and kinematic viscosities are mm²/s² and mm ²/s, respectively.

1.3x00a0;This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see Section 7.

ASTM D2162-2013 中可能用到的儀器設備

誰引用了ASTM D2162-2013 更多引用