1.1 The impact-penetration test described in the
two parts of this International Standard is used for the
assessment of plastic films and thin sheets (herein-
after referred to as films) under an impact stress ap-
plied at right angles to the plane of the film.
1.2 Part 1 of this International Standard can be used
if it is sufficient to characterize the impact behaviour
of the film by an impact-failure energy. Part 2 is used
if a force-deformation or a force-time diagram, re-
corded at practically constant velocity of the striker, is
necessary for characterization of the impact behav-
iour. This applies if:
-- measured quantities derivable only from this dia-
gram are required or
-- only a small number of test specimens are avail-
able.
1.3 The test method is applicable to films of up to
1 mm thickness and makes it possible to compare
impact-penetration forces, biaxial deformabilities and
energy-absorption capacities of films. Furthermore, if
required, the transition region between brittle and
tough behaviour of the film under the conditions of
t~sting can be determined by varying the temperature
or the penetration velocity or the relative humidity
(see also annex B).
NOTE 1 For thicknesses greater than 1 mm, ISO 6603-2
should be used.
1.4 The test results are comparable only if the con-
ditions for preparation of specimens, their thickness
and surfaces, and the test conditions are identical.
Comprehensive evaluation of the reaction to impact
stress requires that the determinations are made as
functions of deformation rate and temperature for
different material variables, such as crystallinity and
moisture content.
Copyright ?2007-2022 ANTPEDIA, All Rights Reserved
京ICP備07018254號 京公網安備1101085018 電信與信息服務業務經營許可證：京ICP證110310號