IEC 61000-3-3 Edition 1.1-2002 電磁兼容性.第3-3部分:限值.不針對條件連接和每相額定電流小于等于16A設備的公共低壓供電系統中電壓變化和波動的限定被誰引用

找不到引用IEC 61000-3-3 Edition 1.1-2002 的標準

非常抱歉，我們暫時無法提供預覽，您可以試試：免費下載 IEC 61000-3-3 Edition 1.1-2002 前三頁，或者稍后再訪問。

注意：點擊下載后，生成下載文件時間比較長，請耐心等待......

適用范圍: This part of IEC 61000-3 is concerned with the limitation of voltage fluctuations and flicker impressed on the public low-voltage system. It specifies limits of voltage changes which may be produced by an equipment tested under specified conditions and gives guidance on methods of assessment. This part of IEC 61000 is applicable to electrical and electronic equipment having an input current equal to or less than 16 A per phase, intended to be connected to public low-voltage distribution systems of between 220 V and 250 V line to neutral at 50 Hz, and not subject to conditional connection. Equipment which does not comply with the limits of this part of IEC 61000 when tested with the reference impedance Zref of 6.4, and which therefore cannot be declared compliant with this part, may be retested or evaluated to show conformity with IEC 61000-3-11. Part 3-11 is applicable to equipment with rated input current ≤75 A per phase and subject to conditional connection. The tests according to this part are type tests. Particular test conditions are given in annex A and the test circuit is shown in figure 1. NOTE The limits in this part of IEC 61000 are based mainly on the subjective severity of flicker imposed on the light from 230 V/60 W coiled-coil filament lamps by fluctuations of the supply voltage. For systems with nominal voltage less than 220 V line to neutral and/or frequency of 60 Hz, the limits and reference circuit values are under consideration.

IEC 61000-3-3 Edition 1.1-2002
電磁兼容性.第3-3部分:限值.不針對條件連接和每相額定電流小于等于16A設備的公共低壓供電系統中電壓變化和波動的限定已作廢