共找到 150 條與 RDF-5 相關的標準，共 10 頁
1.1?This test method is used to determine the size distribution of a RDF-5 sample. Size is defined as the maximum length of the particle, where length
Standard Test Method for Measuring Particle Size Distribution of RDF-5
3.1 The particle size distribution of RDF-5 strongly
Standard Test Method for Measuring Particle Size Distribution of RDF-5
Air drying is performed on a gross sample if it cannot be handled without loss of moisture. A laboratory sample is air dried in order
Standard Test Method for Air Drying RDF-5 for Further Analysis
1.1 This test method covers the process of air drying a gross or laboratory sample of RDF-5. The air dry loss is determined by air drying
Standard Test Method for Air Drying RDF-5 for Further Analysis
1.1 This practice covers the preparation of RDF laboratory samples for analysis, the laboratory samples having been previously obtained from
Standard Practice for Preparing Refuse-Derived Fuel (RDF) Laboratory Samples for Analysis
The particle size distribution of RDF-5 strongly influences the storage and handling characteristics of the fuel. Small particles tend
Standard Test Method for Measuring Particle Size Distribution of RDF-5
1.1 This practice covers a procedure for packaging a refuse-derived fuel sample at its point of origin for shipping this sample to the laboratory
Standard Practice for Packaging and Shipping of Laboratory Samples of Refuse-Derived Fuel (Withdrawn 2002)
Resources saving. Waste management and energy production. Standard test method for thermal characteristic of refused derived fuel macrosamples
Pollution management. Terms and definitions
Standard Definitions of Terms and Abbreviations Relating to Physical and Chemical Characteristics of Refuse Derived Fuel
The purpose of this test method is to provide a means of designating the size classification of RDF-3 for use by consumers
Standard Test Method for Designating the Size of RDF-3 From its Sieve Analysis
This test method is available to producers and users of RDF as a method of determining the weight percent of ash in the analysis
Standard Test Method for Ash in the Analysis Sample of Refuse-Derived Fuel
The collection and treatment of the sample as specified herein is intended for the specific purpose of determining the total moisture
Standard Test Method for Total Moisture in a Refuse-Derived Fuel Laboratory Sample
The standards are available to producers and users of RDF for determining the total sulfur content of the fuel.1.1 These test
Standard Test Methods for Total Sulfur in the Analysis Sample of Refuse-Derived Fuel
1.1 This test method of designating the size of refuse-derived fuel from its sieve analysis is applicable to the classified light fraction (RDF-3
Standard Test Method for Designating the Size of RDF-3 From its Sieve Analysis
