共找到 150 條與 高孔密深穿透射孔器 相關的標準，共 10 頁
Further Effects of Stress on Penetration and Flow Performance of Jet Perforators
Conical penetration hole reamer
Drilled Holes Not Penetrating Through Vessel Wall Section I
Drilled Holes Not Penetrating Through Vessel Wall Section I
Specifies requirements of double hole paper perforators
Perforator specification paper double hole
Specifies dimensions and requirements of single hole paper perforator
Punch, paper, single hole (sleeve punch) specifications
A Study of Perforated Plates with Square Penetration Patterns
"INTRODUCTION This report covers results of the first phase of a new multi-phase API-sponsored program on jet perforator performance. The overall
THE EFFECTS OF STRESS AND PORE PRESSURE ON PENETRATION OF JET PERFORATORS IN BEREA SANDSTONE - FINAL REPORT (INCLUDES ERRATA AND ADDENDA)
Zpracovatel: V?zkumn? ústav matematick?ch stroj?, Praha — St. Hájek Pracovník Dradu pro normalizaci a mě?ení : ing. M. ?ivcov
Data processing machines. Punched cards readers and punches
The Intumescent Fire Seals Association code is a four-part publication setting out the safe methods to ensure that fire integrity is restored
The IFSA Code. Sealing apertures and service penetrations to maintain fire resistance
Zpracovatel: V?zkumn? ústav matematick?ch stroj?, Praha — St. Hájek Pracovník ??adu pro normalizaci a mě?ení: ing. M. ?ivcová Upozornění: Změny
Data processing machines. Punched tape readers and punches
本標準規定了船體結構流水孔、透氣孔、通焊孔和密性焊段孔的型式、尺寸和設計要求。 本標準適用于鋼質船體結構流水孔、透氣孔、通焊孔和密性焊段孔的設計和選用
Hull structure-Drain hole,air hole,clearance hole and scallop for seal welding
Further Theoretical Treatment of Perforated Plates with Square Penetration Patterns
Boiler and Pressure Vessels.Appendix 25 - Mandatory Rules for Drilled Holes not Penetrating Through Vessel Wall
Appendix 25 - Mandatory Rules for Drilled Holes not Penetrating Through Vessel Wall
Boiler and Pressure Vessels.Appendix 30 Rules for Drilled Holes not Penetrating Through Vessel Wall
Appendix 30 Rules for Drilled Holes not Penetrating Through Vessel Wall
本標準規定了高精度可轉位深孔鉆的型式尺寸、技術要求、試驗方法、檢測規則、標志與包裝。本標準適用于鉆孔直徑為9 mm～40 mm、鉆孔深度不大于鉆頭直徑的10倍，冷卻液由刀體注入的裝有沉孔硬質合金可轉位刀片的深孔鉆
Indexable deep holedrill
