共找到 150 條與 容差極限 相關的標準，共 10 頁
RULES POR MEASUREMET OF HORIZONTAL ANGLES ?N TRIANGULATION NETWORK AND ACCEPTABLE ERROR LIMITS
Tolerances allowable deviations and permissible wears of limit gauges
Gives values of the limit deviations for commonly used tolerance classes (zones) for holes and shafts, calculated from the information given in SABS
ISO system of limits and fits Part 2: Tables of standard tolerance grades and limit deviations for holes and shafts
Zpracovatel: V?zkumn? ústav pre petrcchémiu, Nováky (Dr. Ing. Ludmila Urbancová) Pracovník ??adu pro normalizaci a mě?ení: Ing. Matěj Brabec
Limit gap
This Standard relates to simple forms of limit gauges such as cylindrical plug and ring gauges and gap gauges. Provision is made for General gauges
Plain limit gauges limits and tolerances
Limits and fits for engineering - Limits and tolerances
Tolerances and limit deviations for agitator vessels - Part 1: Agitator vessels of metallic materials
Tolerances and limit deviations for agitator vessels - Part 1: Agitator vessels of metallic materials
Tolerances and limit deviations for agitator vessels - Part 1: Agitator vessels of metallic materials
Tables for tolerances on plug, bar, rod, pin, ring and gap gauges based on a graded series of work tolerances from 0.009 to 3.2 mm. Examples
Specification for limits and tolerances on plain limit gauges
Specification for limits and tolerances on plain limit gauges
本標準規定了孔和軸的常用公差帶的極限偏差數值，其數值是按GB/T 1800.3-1998《極限與配合 基礎 第3部分：標準公差和基本偏差數值表》計算得到的。它包括孔的上偏差ES和軸的上偏差es，孔的下偏差EI和軸的下偏差ei的數值。(見圖1）。 本標準適用于圓柱及非圓柱光滑工件的尺寸
Limits and fits Tables of standard tolerance grades and limit deviations for holes and shafts
This British Standard specifies tolerances and limits for simple forms of limit gauges, such as cylindrical plain plug, ring and gap gauges
Specification for limits and tolerances on plain limit gauges
This standard gives values of the limit deviations for commonly used tolerance classes (zones) for holes and shafts calculated from the information
ISO system of limits and fits -- Part 2: Tables of standard tolerance grades and limit deviations for holes and shafts
Cross References: BS 1044-1 ISO/R 1938-11
BS 969. Specification for limits and tolerances on plain limit gauges
