共找到 150 條與 不同側面涂層 相關的標準，共 10 頁
1.1 This test method provides sampling plans that are intended for use in the inspection of metallic and inorganic coatings on products
Standard Test Method of Variables Sampling of Metallic and Inorganic Coatings
El objeto de la presente norma es especificar las características de construcción más importantes de las bandas o correas trans - portadoras de
Structural characteristics of different coated conveyor belts
This commercial item description(CID) covers an aluminum coated roasting pan and an aluminum coated sheet pan with a no-stick coated finish
PAN ROASTING, AND SHEET PAN: ALUMINUM, WITH NO-STICK COATED FINISH
Illustration of the production and evaluation of thermal spray coatings Examples of conventional spray coatings shown in cross-section using different spraying processes
Illustration of the production and evaluation of thermal spray coatings Examples of conventional spray coatings shown in cross-section using different spraying processes
Illustration of the production and evaluation of thermal spray coatings Examples of conventional spray coatings shown in cross-section using different spraying processes
本標準規定了聚偏二氯乙烯(PVDC)、丙烯酸(AC)、改性聚乙烯醇(PVOH)互相搭配涂布在雙向拉伸聚丙烯(BOPP)基膜上制得的涂布薄膜(簡稱BOPP雙面涂布膜)的分類、要求、試驗方法、檢驗規則、標志、包裝、運輸和貯存。本標準適用于以透明雙向拉伸聚丙烯薄膜或白色發泡雙向拉伸聚丙烯薄膜為基材膜,一面
Biaxially oriented polypropylene both sides coated film with diversified coating materials
Describes a procedure for measuring the polarization-mode dispersion (PMD) of single-mode optical fibers. This standard was listed for public review
Coating Geometry Measurement for Optical Fiber Side View Method
Sampling inspection permits the estimation of the overall quality of a group of product articles through the inspection of a relatively small
Standard Test Method of Variables Sampling of Metallic and Inorganic Coatings
1.1 This method provides sampling plans that are intended for use in the inspection of metallic and inorganic coatings on products for the purpose
Standard Test Method of Variables Sampling of Metallic and Inorganic Coatings
1.1 This document contains a list of standards related to nondestructive testing that were developed by ASTM committees other than Committee E-7
Standards Related to Nondestructive Testing Developed by ASTM Committees Other Than Committee E-7 (This is not an ASTM standard; available as PDF, only)
This commercial item description(CID) covers stainless steel coated steam table pans with non-stick coated
PANS, STAINLESS STEEL, WITH NO-STICK COATED FINISH
Covers the design, installation and testing of profiled sheeting of length exceeding 1 m and intended for use as roofing and side cladding. Does
Roof and side cladding
Un perfil angular extruído de lados a = 40, b = 25 y de espesor h = 3 mm fabricado con la aleación L-3420 UNE 38-342 en estado T6, se designar
Extrusion profiles of aluminum and aluminum alloys. Contours at different side angles. Measurements and tolerances
Specification for undercoat and finishing paints
